| Table of Contents | ||
|---|---|---|
|
...
ECU Connect
With the Cruise buttons
NOTE: Currently, MS mode is not stored in the ECU. You will need to change it after every key off cycle. (This is scheduled for the V3 release.)
Changing Map Switch Mode Via ECU Connect
...
Ensure you are in a Map Switch Mode that has LC enabled in the ROM
Press and hold the traction control button to disable the traction control
For Corolla make sure you're in sport/custom mode and hold down VSC button until the EXPERT light turns off.
Depress the Clutch Fully (to the bottom of travel)
Quickly Press the Accel Pedal to the bottom of travel (adjustable activation points)
Wait for the RPM to increase to the setpoint
the Launch RPM can be adjusted by using the + RES or - SET buttons
Release the clutch to start the Launch
...
All of the calibrated conditions for that blend will then be used.
NOTE: Currently, MS mode is not stored in the ECU. You must change back to the correct MS mode for the given ethanol content after every key off cycle. (Full Flexfuel is scheduled for the V3 release)
Map Listing
...
Calibrating Ethanol Blends
...
Final Lambda Target = (Lambda Tgt *( 1 - EB Fuel Map blend)) + (EB Target Lambda Blend x EB Target Lambda)
Note: If the OEM code determines that a Different Lambda Target mode (one other than 250) is required, it will overwrite the RR value. Watch out for Lambda target source changes and address them as required.
Ethanol Blend Ignition Timing
...