Bench Unlock Tool

Bench Unlock Tool

This software tool is included in ProECU and allows unlocking specific ECUs on the bench (ECU is taken out of the car).

Supported hardware interfaces

Currently, the following interfaces are supported:

How to use

  1. Connect the hardware interface to the PC using the supplied USB cable

  2. Connect the hardware interface to the supplied power adapter

  3. Connect the power adapter to the mains

  4. In ProECU, select Tools > Bench Programmer Tool

    ProECU_BenchProgrammerToolMenu.png
    ProECU_BenchProgrammerToolWindow.png
  5. Select the ECU to program

  6. Connect the ECU to the hardware interface, using either:

    • An ECU-specific bench programming cable.

    • A breakout cable, connecting individual wires to the ECU pins.
      To see the required connections, click the Help button.

  7. Perform the required operation (see below).

Identification

Reads the Calibration IDs and other identifying information from ECU.

Help

Displays information on how to connect the selected ECU to the hardware interface.

Unlock

Unlocks a stock ECU. The required number of Flash Points will be deducted from your Dongle.

Flash Stock ROM

Programs a stock ROM into the ECU. The ECU will effectively be re-locked.

Backup ECU

Creates a backup of the ECU in its current state, including the EEPROM data.

Restore ECU

Restores a previously created ECU backup.
The EEPROM data is only restored if the “Program EEPROM” checkbox is selected.