...
These two changes should be sufficient to run low boost and fuel correctly until you reach the reading limit of the stock MAF sensor or you max out part of the stock fuel system.
Fitting Omni 3 bar MAP sensor
We have managed to get our car here to start, idle, run & drive with no P0107 error using the following changes when using a 3 bar map sensor. This was using an Omni 3 bar map sensor fitted, just as we have used on the Gen1 cars for years.
The following maps needed to be changed:
...
This differences file should do most of the hard work for you but if you are using a different brand of sensor you need to check the values are correct. Keep in mind the ECU for the 2nd Gen FA24 cars uses different pressure units to the 1st Gen FA20 cars so some unit conversion may be needed to get it to work correctly.
| View file | ||
|---|---|---|
|