Per Gear Maximums
These tables are still affected by load and torque limits, as such those will need to be modified if targeting values higher than those limits. |
Torque Desired Max (RaceROM)
This table allows you to set a desired max amount of torque per gear by RPM. This torque request is scaled but the output of the driver demand maps such as Torque - Driver→Pedal Request - Drive AT and related maps.
Only used when "Use RaceROM torque desired max maps" is enabled in RaceROM Special Features→Enable Special Features and overwrites the values from the map Torque - Engine→Clutch Torque Maximum (which can be left stock if the RaceROM map is enabled and calibrated).
If Flexfuel is also enabled, it's blended with RaceROM FlexFuel->Torque→FlexFuel Torque Desired Max
Torque Desired Max Scalar by MS Mode (RaceROM)
Allows a percentage multiplier to be applied to the Torque Desired Max (RaceROM) table based on map slot. This can be handy to allow map modes of varying power levels for use with different drivers / driving conditions. These can be customised further to allow for different percentage changes for normal vs sport mode.
Map modes are in a descending order with the top of each section being slot 1.
The final output of the RaceROM Torque Desired Max be logged using the Torque Desired Max logging parameter.
Torque Request Multiplier
Since the factory torque requests from the pedal are percentage based, as you increase the amount of torque being targeted either through the RaceROM maps, Flex Fuel (or even the stock maps) you can run into some undesireable behavior. At low throttle positions you'll still be requesting the same percentage of torque, but because your targets are higher, you'll be targeting more torque than you'll really want to see at those lower pedal positions or gears.
For example, if you're targeting 20% more torque than stock, than you'll also be targeting 20% more torque than stock at 2% throttle.
This table provides a function allowing you to set a multiplier curve to adjust the sensitivity of the accelerator pedal per map slot to target a lower level of torque than it would otherwise be trying to reach. This works in conjunction with the factory Torque-Driver → Pedal Request maps.
Load Limit - Gear (RaceROM)
This table allows you to set different load limits by RPM per gear, they are used in conjunction with the OEM load limits. The lowest value from any of the active limits will set the final limit on the target load.
Load Limit Scalar by MS (map slot) Mode
This map sets a percentage multiplier to the Load Limit -Gear (RaceROM) value by map slot. This can be handy to have map modes of varying power levels for use with different drivers / driving conditions. These can be customised further to allow for different percentage changes for normal vs sport mode.
Map modes are in a descending order with the top of each section being slot 1.